40000 SafetyNET pReal-time industrial Ethernet protocol.
Safety-critical automation. Isolate.
| Transport | Status | Meaning |
|---|---|---|
| TCP | Yes | Assigned by IANA and standardized, specified, or widely used on this port. |
| UDP | — | Not applicable for this transport. |
| SCTP | — | Not applicable for this transport. |
| DCCP | — | Not applicable for this transport. |
Registered (1024–49151). Assigned by IANA on request; usable without elevated privileges on most systems.
Browse all ports →
Copy-ready inbound rules for the active transports. Replace every <source> placeholder with the specific host, subnet, or CIDR that should reach this port.
sudo ufw allow proto tcp from <source> to any port 40000Allow TCP 40000 (SafetyNET p). Replace <source> with the network/host that should reach it.
sudo firewall-cmd --permanent --add-rich-rule='rule family="ipv4" source address="<source>" port port="40000" protocol="tcp" accept'Allow TCP 40000 (SafetyNET p) from <source>. Run 'firewall-cmd --reload' afterwards.
nft add rule inet filter input ip saddr <source> tcp dport 40000 acceptAllow TCP 40000 (SafetyNET p). Assumes table 'inet filter' with an 'input' chain.
sudo iptables -A INPUT -p tcp -s <source> --dport 40000 -j ACCEPTAllow TCP 40000 (SafetyNET p). Persist with iptables-save/netfilter-persistent.
az network nsg rule create -g <resource-group> --nsg-name <nsg> -n Allow-safetynetp-40000 --priority 1000 --access Allow --direction Inbound --protocol TCP --source-address-prefixes <source> --destination-port-ranges 40000Inbound rule for 40000 (SafetyNET p). Set <source> to a CIDR; lower priority number = higher precedence.
aws ec2 authorize-security-group-ingress --group-id <sg-id> --ip-permissions IpProtocol=tcp,FromPort=40000,ToPort=40000,IpRanges="[{CidrIp=<source-cidr>}]"Inbound TCP 40000 (SafetyNET p). Replace <source-cidr> (e.g. 10.0.0.0/16).
gcloud compute firewall-rules create allow-safetynetp-40000 --direction=INGRESS --action=ALLOW --rules=tcp:40000 --source-ranges=<source-cidr> --network=<network>Ingress rule for 40000 (SafetyNET p). Scope with --source-ranges and optionally --target-tags.
netsh advfirewall firewall add rule name="Allow SafetyNET p 40000/TCP" dir=in action=allow protocol=TCP localport=40000 remoteip=<source>Inbound TCP 40000 (SafetyNET p). Set remoteip to a host/subnet; 'any' is discouraged.
New-NetFirewallRule -DisplayName "Allow SafetyNET p 40000/TCP" -Direction Inbound -Action Allow -Protocol TCP -LocalPort 40000 -RemoteAddress <source>Inbound TCP 40000 (SafetyNET p). Replace <source> with a host or subnet.
Rules are generated only for transports marked active for this port. They default to an inbound allow with an explicit source placeholder — never any. Review direction, scope, and rule precedence before applying in production.